Bafang Spacer – BBS01 BBS02 BBSHD – Motor Spacer Set – 1+2+3mm

If you are trying to fit your motor and have found that your clamping plate and motor bosses don’t quite line up due to BB widths, you could drive yourself insane trying to use a pile of washers…. or make it easy on yourself by using a specific Bafang Spacer Set that not only reduces your headaches but looks great in doing so. Use Lekkie’s Motorspacer Set – 1+2+3mm for wider bottom bracket frames(or 68mm frames that you’ve had to space out on the drive side) to take up the space between the motor and motor clamping plate. The combination can go from 1mm to 6mm in 1mm increments to suit your requirements

Note: These spacers sit between the Clamping plate and the Motor mounting lugs, two M6 x 16mm mounting screws are included to ensure adequate thread engagement into the motor. Length will vary depending on the install, if only spacing 1-2mm the stock screw should be fine.